OPX Plug-in Isolation Card

The Plug-in Off Premise Extension (OPX) Card is used to provide high voltage isolation for a wide variety of telephone voice grade applications involving the bi-directional transmission of AC and DC voltage. It is available in two options, as listed below

• 7501-16B designed for a -24 Vdc source referenced to station ground
• 7501-16C designed for a -48 Vdc source referenced to station ground

Applications:

• Off Premises Extension (OPX)
• POTS
• Direct Inward Dial (DID) loop start
• Automatic/Manual ring down
• Radio keying
• Loop start telephone
• Call waiting pulse
• Forward disconnect
• POTS with Caller ID
• Coin telephone (two cards required)
• Simplex continuity when used with four-wire DX signalling
• Fax and dial-up “smart” modems (up to 56.6 kB modem, speed of 45.3 kB/s if line permits)

Features

• The card may be used with all Teleline Isolator Shelves
• The OPX Card is completely bi-directional to all loop signalling, i.e. line voltages can originate from either Station or CO side loops. Bi-directional modulator/demodulators are used to realize a circuit which behaves as an ideal 1:1 isolation device
• Varistors provide transient voltage protection to the isolation device
• The OPX Card provides low loss, full duplex DC-to-voice band communication
• The OPX Card transmits on/off-hook, dial pulses or touch tone signalling, ringing, polarity reversals, AC and DC voltage and current levels
• Impedances applied to either side of the card are reflected to the opposite side

The OPX Plug-in Isolation Card can be housed in any vintage of the 3-card shelf, the 5-card shelf, the 8-card shelf, or in any of our High Voltage Interface (HVI) pre-configured units.